Free Fortinet NSE6_FSW-7.2 Exam Questions

Become Fortinet Certified with updated NSE6_FSW-7.2 exam questions and correct answers

Page: 1 / 12

Total 56 Questions | Updated On: Jan 10, 2025

Add To Cart

Question 1

Which feature should you enable to reduce the number or unwanted IGMP reports processed by the IGMP querier?

A : Enable the IGMP flood setting on the static port for all multicast groups.

B : Enable the IGMP flood reports setting on the mRouter port.

C : Enable IGMP snooping proxy.

D : Enable IGMP flood unknown multicast traffic on the global setting.

Answer: C

Question 2

Refer to the diagnostic output:

What makes the use of the sniffer command on the FortiSwitch CLI unreliable on__port__23?

A : The types of packets captured is limited.

B : Just the port egress payloads are printed on CLI.

C : Only untagged VLAN traffic can be captured.

D : The switch port might be used as a trunk member

Answer: D

Question 3

Which two statements about the FortiLink authorization process are true? (Choose two.)

A : The administrator must manually pre-authorize FortiGate on FortiSwitch by adding the FortiGate serial number.

B : FortiSwitch requires a reboot to complete the authorization process.

C : A FortiLink frame is sent by FortiGate to FortiSwitch to complete the authorization.

D : FortiLink authorization sets the FortiSwitch management mode to FortiLink.

Answer: C,D

Question 4

Which two types of Layer 3 interfaces can participate in dynamic routing on FortiSwitch? (Choose two.)

A : Detected management interfaces

B : Loopback interfaces

C : Switch virtual interfaces

D : Physical interfaces

Answer: B,C

Question 5

Refer to the exhibit.

The profile shown in the exhibit is assigned to a group of managed FortiSwitch ports, and these ports are connected to endpoints which are powered by PoE. Which configuration action can you perform on the LLDP profile to cause these endpoints to exchange PoE information and negotiate power with the managed FortiSwitch?

A : Create new a LLDP-MED application type to define the PoE parameters.

B : Assign a new LLDP profile to handle different LLDP-MED TLVs.

C : Define an LLDP-MED location ID to use standard protocols for power.

D : Add power management as part of LLDP-MED TLVs to advertise.

Answer: D

Page: 1 / 12

Total 56 Questions | Updated On: Jan 10, 2025

Add To Cart