Free NetApp NS0-184 Exam Questions

Become NetApp Certified with updated NS0-184 exam questions and correct answers

Page: 1 / 18

Total 86 Questions | Updated On: Nov 19, 2024

Add To Cart

Question 1

You are expanding an existing 4-node ONTAP 9.8 cluster with a FAS8300 HA pair by adding a new FAS500f

HA pair. Before the expansion, you are asked to save the configuration of the cluster to a backup file.

In this scenario, which two ONTAP configuration backup methods are available? (Choose two.)

A : storage VM

B : node

C : cluster

D : switch

Answer: B,C

Question 2

On which type of network interfaces are the cluster interconnect LIFs created?

A : on an FC or FCoE port

B : on an interface group

C : on a UTA port shared with other LIFs

D : on a physical port

Answer: D

Question 3

After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.

In this scenario, which two commands would you use to accomplish this task? (Choose two.)

A : system node autosupport history show

B : system node autosupport check show

C : system node autosupport destination show

D : system node autosupport invoke

Answer: A,B

Question 4

You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups

for higher performance and resiliency.

Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements?

(Choose two.)

A : Use ports from different NICs.

B : Use ports from the same NICs.

C : Use ports with different chipsets.

D : Use ports with the same chipsets.

Answer: A,D

Question 5

Click the Exhibit button.

You are attempting to add a new ONTAP 9.7 node to your ONTAP 9.8 NetApp cluster. After attempting to add

the node, it fails as shown in the exhibit.

What are two nondisruptive ways to add the new node to your ONTAP cluster? (Choose two.)

A : Revert the cluster from ONTAP 9.8 to ONTAP 9.7.

B : Re-initialize all the nodes in the ONTAP cluster with ONTAP 9.7.

C : Upgrade the new node from ONTAP 9.7 to ONTAP 9.8.

D : Add the node using the -allow-mixed-version- parameter.

Answer: C,D

Page: 1 / 18

Total 86 Questions | Updated On: Nov 19, 2024

Add To Cart