Free Juniper JN0-480 Exam Questions

Become Juniper Certified with updated JN0-480 exam questions and correct answers

Page: 1 / 13

Total 65 Questions | Updated On: Nov 12, 2024

Add To Cart

Question 1

Exhibit.

You are working to build an ESI-LAG for a multihomed server. The ESI-LAG is not coming up as

multihomed.

Referring to the exhibit, what are two solutions to this problem? (Choose two.)

A : The gateway IP addresses on both devices must be different.

B : The LACP system ID on both devices must be the same.

C : The loopback IP addresses on both devices must be the same.

D : The ESI ID on both devices must be the same.

Answer: B,D

Question 2

When an agent installation is successful, devices are placed into which state using the Juniper Apstra Ul?

A : IS-MAINT

B : OOS-READY

C : OOS-QUARANTINED

D : IS-ACTIVE

Answer: C

Question 3

You are working with a three-stage IP fabric using EBGP for peering.

In this scenario, which two actions are required to implement ECMP? (Choose two.)

A : Usea load balancing policy applied to the forwarding table as an export policy.

B : Use a load balancing policy applied to BGP as an export policy.

C : Use the multipath multiple-as BGP parameter.

D : Use a load balancing policy applied lo BGP as an import policy.

Answer: B,C

Question 4

Which protocol is used to advertise EVPN routes?

A : OSPF

B : BGP

C : IS-IS

D : RIP

Answer: B

Question 5

You are adding a new switch to Juniper Apstra software. The Managed Devices page shows the "0 OS-Quarantined" status. What is the proper next step to make the device ready for use in a blueprint?

A : Acknowledge the device.

B : Take the device out of maintenance mode.

C : Install the agent for the device.

D : Take the device out of drain state.

Answer: A

Page: 1 / 13

Total 65 Questions | Updated On: Nov 12, 2024

Add To Cart